Brazil government has started to enforce their standard for plug and cord. Therefore, all electric products, both low and high voltage, must comply with the following standard.
Standard
-NBR6147 = IEC60884-1: 1994 and amendments 1:1994 and 2:1995.
-Elements affected are PLUG and CORD.
-Plug must be 4.00mm Swiss round pin with insulator (see drawing attached)
-Both items must be certified.
-Both items must have the certified agency logo printed
The plug and cord must be approved by the local Brazilian agency or by an approved agency or plug/cord be purchased from an approved supplier.
Implementation
All products entering the country by January 1, 2003 must comply with the above standard.
Approved Agencies
If plug and/or cord have been approved by any of the following agencies, then the local Brazilian agency would accept their test report as valid for certification.
FIMKO
IMQ
VDE
LCIE
OVE
SEMKO
KEMA
NEMKO
AENOR
CEBEC
Approved Suppliers
If plug and/or cord were purchased from any of the following suppliers, then the local Brazilian agency would accept their test report as valid for certification. These suppliers are already certified companies. |
发表于 2011-10-21 22:47:01
收藏